Materials Handling Electrical power UNIT 2
This power unit functions power up gravity down circuit. Activate the start off solenoid to start out the motor to lift the machine. The lowing motion is activated by the solenoid valve using the reducing velocity managed by the stress compensated flow control valve. Items of this series is often extensively used in the industry of logistic devices such as fork lift, mini lift table, etc.
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic elements concerned before mounting the power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities, N46 hydraulic oil is suggested .
4. Oil transforming is required following the original 100 operation hours,afterwards once every 3000 hrs.
five. The power unit must be mounted horizontally.
Materials Handling Electrical power UNIT 1
This electrical power unit is created for the fork lift industry, consisting of really efficient gear pump, DC motor, manual increase and lower valve, tank, ect. The up and down motion are managed from the lever of your guide release valve, that is outfitted with an electrical switch to activate the motor. The lowing velocity is controlled through the stress compensated movement control valve.
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned prior to installation of the power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities, N46 hydraulic oil is proposed .
4. Oil altering is required following the first 100 operation hrs, afterwards when each 3000 hours.
five. The power unit shown is created to be mounted horizontally.