Forged 5 Bolt Trailer Stub Axle and Hub SKF CODE BAA0026

Features and Benefits

• Low runout reduces noise and vibration for improved braking performance.
• Premium seals are designed to help prevent installation damage and provide enhanced protection for extended bearing life and durability.
• High-quality bearings engineered for long life and fuel efficiency (tapered roller and ball bearings).
• Advanced sensor technology monitors the wheel speed of the Anti-lock Braking System (ABS).
• Precision fit controls internal bearing clearance to help maintain proper bearing settings.
• Constructed from clean, high-quality, high-alloy steel for strength and durability.
• Contains premium grease to help improve performance and extend bearing life: lower torque and temperature for greater bearing roller traction and enhanced protection against wear, rust, and contamination.

Strictly Test Product Performance

• Wheel Durability and Fatigue Testing: Verifying strength and structural fatigue performance (cracking resistance).
• Flange Runout Test: Helps ensure low runout and rotor deflection for better braking performance.
• Stud Torsion and Push-Out Test: Helps ensure that the interface between the stud and the hub is strong to prevent peeling (the stud should break first to replace the existing hub) - this is essential for strength and proper installation.
• Bearing Durability Testing: Verifies rolling contact fatigue performance (resistance to spalling damage) to help ensure extended bearing life and improved performance.
• Seal Durability and Performance Testing: Seals undergo mud, high temperature, and water spray testing to verify performance and durability.
• ABS sensor output testing: Verification that the sensor meets system requirements and will work properly with ABS/vehicle dynamics system – signal Bearing Durability Testing: Verifies rolling contact fatigue performance (resistance to spalling damage) to help ensure extended bearing life and improved performance.
• Safe Boot Process: Visual and functional inspection to ensure readiness for installation.

How to use the wheel hub removal tool

A hub removal tool is an essential tool when repairing wheel bearings. This tool is designed to help you remove stubborn wheel bearings without damaging expensive parts or wheel bearing assemblies. It is a 2-in-1 tool that fits over and through the hub and assembly stud to remove wheel bearings.
First, remove the hub assembly. It is held in place by a few bolts at the back. You may need a breaker lever to loosen the bolts. After removing the hub, you can assemble the rest of the vehicle. Before replacing the wheel, the steering knuckle assembly, disc brake caliper, axle nut, and front tire should be installed.
Another hub removal tool is the slide hammer. This tool has been around for years and has been modified to fit wheel bearing assemblies. It was originally used to remove dents and seals and was later retrofitted by attaching steel plates to axle bolts. The tool requires very little technical skills to use. It is important to remember that if the wheel bearing assembly is a press fit design, the slide hammer can only pop out of the hub.
Hub removal tools are also important for replacing the wheel bearing assemblies. This tool has a wide range of applications and wide range of uses. It can be used for the front and rear wheels of small pickups, imported, and even domestic cars. The tool can be stored in a convenient carrying case made of high-quality ABS material.